Перегляд за Автор "Piddubnyi, Volodymyr"

Зараз показуємо 1 - 3 з 3

Effects of multicomponent mixture "Solodok super" on the quality of wheat bread enriched with a sprouted grain mixture
(2021) Bilyk, Olena; Burchenko, Liudmila; Bondarenko, Yuliia; Piddubnyi, Volodymyr
This paper is dedicated to improving the technology of bakery products made from wheat flour with added mixture of sprouted grains. The sprouted grain mixture (SGM) contains wheat, barley, corn, and oat grains, produced by “Choice” LLC (Kyiv, Ukraine). It has been proven that increasing the amount of grain mixture to 15% to weight of flour has a negative impact on sensory, physical, and chemical qualities of bread products. This amount of sprouted grain mixture reduces viscosity and increases spreading of dough, which leads to the smaller volume of the finished products. Thus when adding 15% of the mixture, it is recommended to use multicomponent mixtures. Multicomponent mixture "Solodok SUPER" has been developed and its optimal dosage has been established. Using it increases specific volume of bread products and improves their porosity and shape stability.
Studying the effect of milk processing products on the structural-mechanical properties of wheat flour dough
(2021) Bilyk, Olena; Vasylchenko, Tetyana; Kochubei-Lytvynenko, Oksana; Bondarenko, Yuliia; Piddubnyi, Volodymyr
Dry whey enriched with magnesium and manganese (DW) that contains protein in the amount of 13 %, and a whey protein concentrate (WPC) with a protein content of 65 %, have been chosen as functional bases in the production of complex baking improvers with a targeted effect. When developing a composition of the complex improver, the rational dosage of DW is 2 % by weight of flour, and that of WPC – 3 % by weight of flour. Adding DW and WPC during the kneading of wheat flour dough predetermines a decrease in its gluten content, by 4 % and 6.1 %, respectively, after 20 minutes of the dough rest, and by 7.5 and 10.7 % after two hours of the dough fermentation. This is due to the introduction of lactic acid with milk processing products, which peptizes proteins resulting in that the gluten proteins are partially converted into water-soluble ones. If DW and WPC are included in the dough formulation, there is an increase in the total amount of proteins in it, as well as a change in their fractional composition: the mass fraction of water-soluble and intermediate fractions of proteins increases while the amount of gluten proteins decreases. That confirms a decrease in the amount of gluten washed out from the dough with the addition of DW and WPC. Increasing the mass fraction of water-soluble proteins contributes to the intensification of the fermentation process through the additional nutrition of microflora with nitrogenous substances and an increase in the content of free water in the dough, which predetermines its thinning. It was established that despite the high water absorption capacity of DW and WPC, the water-absorbing ability of the dough that contains them decreases compared to control by 8.4 and 10.7 %, respectively. Studying the dough at the farinograph has shown that in the case of using DW, its stability is somewhat prolonged while in the case of WPC introduction the dough stability is extended by almost 10 minutes, which leads to prolonging the dough kneading. Along with this, in the case of using WPC, there is a rapid descent of the farinogram curve, which could lead to a strong weakening of the dough during fermentation and rest, even though that the thinning after 12 minutes is lower than that of control
Thermodynamic analysis of the thermal-technological complex of sugar production: criteria for energy efficiency of an enterprise
(2021) Samiilenko, Serhii; Bondar, Vladimir; Piddubnyi, Volodymyr; Bilyk, Olena; Shutyuk, Vitaliy; Fedoriv, Viktor
A procedure for analyzing the effectiveness of using fuel and energy resources (FER) in sugar production, based on the developed idealized circuit of the thermal-technological complex (TTC) as the base for comparison was presented. This procedure makes it possible to quantify the level of perfection of existing and proposed thermal circuits, as well as the impact of measures for enhancing energy efficiency on their perfection. By idealizing technological and energy processes, a hypothetical TTC was synthesized, for which the minimum possible energy and entropy characteristics are determined. Under these conditions, the minimum possible heat consumption for the implementation of technological processes according to the classical heat technology circuit was calculated – 118.40 MJ/t; a "minimum" total increase in entropy from irreversible processes of the HTC – 314.68 kJ/(t•K); a minimum complex magnitude of specific consumption of conventional fuel – 0.8 % to m. b. The determined characteristics are absolute criteria for the efficiency of sugar production systems, since it is impossible to reach lower values under existing technology, quality of raw materials and other conditions. The content of the criteria of energy efficiency of TTC was stated and the system of coefficients was proposed: coefficient of total energy efficiency of the TTC, coefficient of energy efficiency of the system of heat supply of the technological processes and coefficients of energy efficiency of internal and external structures of the TTC. The proposed criteria provide an objective and thermodynamically correct characteristic of the TTC of different structures. The presented results of analysis of various measures for increasing the energy efficiency of sugar production show that only a gradual comprehensive reconstruction of an enterprise makes it possible to consistently reduce the FER consumption for technological needs, approaching the boundary values.